Soap cutting equipment, built in Canada.
The Arbutus 120 turns a full 120 lb block into finished bars in two strokes. Stainless where it touches soap, guarded where it matters, and supported by the shop that built it.
One operator. Two strokes. Done.
- LoadThe built-in hoist sets the mold on the pull-out table. Lift the walls off and the block stays on its pad.
- Loaf cutSlide in, close the door, hold the button. A stainless wire grid splits the block into 30 logs.
- Bar cutSwap to the bar frame, lay the logs down and cut again. Each log becomes thirteen bars.
- UnloadSlide the table out and move the bars to cure.
Simple machines that do one job well
Balanced drive
Two cylinders push straight down over the frame's sides, so the cut stays level from top to bottom.
Food-safe contact
Only 304 stainless and food-grade HDPE touch your soap. No mild steel, zinc or brass.
Safe by design
Fully enclosed. It moves only with the door shut, the table home and the button held.
Built to your bar
Wire spacing, pads and molds are set to the block and bar sizes you sell.
Canadian support
Quoted in Canadian dollars. Parts, wires and service a phone call away.
Complete package
Cutter, two cutting frames, molds, pads, dollies and a built-in hoist.
From poured block to cured bars
Designed for craft and growing soap makers who pour in full blocks and want clean, repeatable bars without importing a machine.
Build slots fill in order
Tell us about your soap and we'll send a quote and a build date.